HP 7000 dl Router manual Command Reference GuideTunnel Configuration Command Set, Cost value

Command Reference GuideTunnel Configuration Command Set

ip ospf

Use the ip ospf command to customize OSPF settings (if needed).

Syntax Description

authentication-key	Specifies a simple-text authentication password to be used
	by other routers using <password> the OSPF simple
	password authentication.
cost <value>	Specifies the OSPF cost of sending a packet on the interface.
	This value overrides any computed cost value.
	Range: 1 to 65535.
dead-interval <seconds>	Sets the maximum interval allowed between hello packets. If
	the maximum is exceeded, neighboring devices will
	determine that the device is down. Range: 0 to 32767.
hello-interval <seconds>	Specifies the interval between hello packets sent on the
	interface. Range: 0 to 32767.
message-digest-key<keyid> md5 <key> Configures OSPF Message Digest 5 (MD5) authentication
	(16-byte max) keys.
priority <value>	Set the OSPF priority. The value set in this field helps
	determine the designated router for this network.
	Range: 0 to 255.
retransmit-interval <seconds>	Specifies the time between link-state advertisements (LSAs).
	Range: 0 to 32767.
transmit-delay <seconds>	Sets the estimated time required to send an LSA on the
	interface. Range: 0 to 32767.

Default Values

retransmit-interval <seconds>	5 seconds
transmit-delay <seconds>	1 second
hello-interval <seconds>	10 seconds: Ethernet, point-to-point, Frame Relay, Tunnel,
	and PPP
dead-interval <seconds>	40 seconds

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet (eth 0/1), PPP virtual interfaces (ppp 1), HDLC
	virtual interfaces (hdlc 1), Frame Relay virtual sub-interfaces (fr 1.20), tunnel
	interfaces (tunnel 1), and VLAN interface (vlan 1).

Usage Example

The following example sets the maximum number of seconds allowed between hello packets to 25,000:

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 795