HP 7000 dl Router manual Show spanning-tree bridgegroup#, Enable #show spanning-tree

SROS Command Line Interface Reference Guide Enable Mode Command Set

show spanning-tree <bridgegroup#>

Use the show spanning-treecommand to display the status of the spanning-tree protocol.

Syntax Description

<bridgegroup#> Optional. Display spanning-tree for a specific bridge group.

Default Values

No default value necessary for this command.

Command Modes

# Enable Command Mode

Usage Examples

The following is an example output using the show spanning-treecommand:

>enable

#show spanning-tree

Spanning Tree enabled protocol ieee
Root ID	Priority	32768
Address		00:a0:c8:00:88:41
We are the root of the spanning tree
Hello Time		2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID	Priority	32768
Address		00:a0:c8:00:88:41
Hello Time		2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time		300
Interface		Role	Sts	Cost	Prio.Nbr	Type
-------------------		-------------------	-------------------	-----------	-------------	---------------
eth 0/2		Desg	FWD	19	128.2	P2p

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 187