HP 7000 dl Router manual Interface port-type slot/port, Config#interface serial 1/1

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

interface <port-type> <slot/port>

Activates the Interface Configuration Mode for the listed physical interface.

Syntax Description

<port-type>	Identifies the physical port type of the installed Interface Module, Backup Module
	or Ethernet port. Type interface ? for a complete list of valid interfaces.
<slot/port>	Specifies an interface based on its physical location (slot and port). For example,
	if you have a T1/DSX-1 installed in Slot 1 of an Secure Router OS product:
	• The WAN-T1port would be specified in the CLI as t1 1/1.
	• The DSX-1port would be specified as t1 1/2.
	• If (for example) a backup module is also installed, then the DBU port would be
	specified as bri 1/3.
	• If you are specifying a port that is built into the base unit (e.g., the Ethernet
	port), the slot number is 0. For example, the Ethernet (LAN) port would be
	specified as ethernet 0/1.

Default Values

No default values required for this command.

Command Modes

(config)# Global Configuration Mode required

Usage Examples

The following example enters the serial interface for a serial module installed in slot 1:

(config)#interface serial 1/1

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 240