HP 7000 dl Router E1 Interface Configuration Command SET, E1 Interface Configuration Command Set

SROS Command Line Interface Reference Guide E1 Interface Configuration Command Set

E1 INTERFACE CONFIGURATION COMMAND SET

To activate the E1 Interface Configuration , enter the interface e1 command (and specify the E1 port) at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface e1 1/1

Router(config-e1 1/1)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930 shutdown on page 935

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

clock source [internal line through] on page 531 coding [ami hdb3] on page 532

framing [crc4] on page 533 loop-alarm-detecton page 534 loopback network [line] on page 535 loopback remote v54 on page 536 remote-alarm [rai ais] on page 537 remote-loopbackon page 538 sa4tx-bit [0 1] on page 539

show test-patternon page 540 snmp trap link-statuson page 541

tdm-group <group number> timeslots <1-31> speed [56 64] on page 542 test-pattern [ones zeros clear insert p215 p220 p511] on page 543 ts16 on page 544

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 530