HP 7000 dl Router manual Clear ip igmp group group-address interface, #show ip igmp groups

SROS Command Line Interface Reference Guide Enable Mode Command Set

clear ip igmp group [<group-address> <interface>]

Use the clear ip igmp group command to clear entries from the Internet Group Management Protocol (IGMP) tables. If no address or interface is specified, all non-static IGMP groups are cleared with this command.

Syntax Description

<group-address>	Optional. Specifies the multicast IP address of the multicast group.
<interface>	Optional. Designates the clearing of parameters for a specific interface (in the format
	type slot/port). For example: eth 0/1.

Default Values

No default value necessary for this command.

Command Modes

# Enable Command Mode

Usage Examples

The following example shows output for the show igmp groups command before and after a clear ip igmp group command is issued. This example clears the IGMP entry that was registered dynamically by a host. Interfaces that are statically joined are not cleared:

#show ip igmp groups

IGMP Connected Group Membership Group Address

Interface

Uptime

Expires

Last Reporter 172.0.1.50 Loopback100 01:22:59 00:02:46 172.23.23.1 172.1.1.1 Ethernet0/1 00:00:14 00:02:45 1.1.1.2 172.1.1.1 Loopback100 01:22:59

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 33