HP 7000 dl Router manual Dhcp Pool Command SET, Dhcp Pool Command Set

SROS Command Line Interface Reference Guide DHCP Pool Command Set

DHCP POOL COMMAND SET

To activate the DHCP Pool , enter the ip dhcp-server pool command at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#ip dhcp-server pool MyPool

Router(config-dhcp)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 do on page 928

end on page 929 exit on page 930

All other commands for this command set are described in this section in alphabetical order.

client-identifier <identifier> on page 356 client-name <name> on page 358 default-router <address> <secondary> on page 359 default-router <address> <secondary> on page 359 domain-name <domain> on page 361 hardware-address<hardware-address> <type> on page 362

host <address> [<subnet mask> or <prefix length>] on page 364 lease <days> <hours> <minutes> on page 365 netbios-name-server <address> <secondary> on page 366 netbios-node-type <type> on page 367

network <address> [<subnet mask> or <prefix length>] on page 368 ntp-server <ip address> on page 369

option <option value> [ascii hex ip] <value> on page 370 tftp-server <server> on page 371

timezone-offset <offset> on page 372

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 355