SROS Command Line Interface Reference Guide

Ethernet Interface Configuration Command Set

 

 

Not all Ethernet commands apply to all Ethernet types. Use the ? command to display a list of valid commands. For example:

Router>enable

 

Password:

 

 

Router#config term

 

Router(config)#int eth 0/1

Note

Router(config-eth 0/1)#?

 

access-policy

- Assign access control policy for this interface

 

alias

- A text name assigned by an SNMP NMS

 

arp

- Set ARP commands

 

bandwidth

- Set bandwidth informational parameter

 

bridge-group

- Assign the current interface to a bridge group

 

etc....

 

 

 

 

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 436

arp arpa on page 439

bandwidth <value> on page 440 bridge-group <group#> on page 441 crypto map <mapname> on page 442

dynamic-dns [dyndns dyndns-custom dyndns-static] <hostname> <username> <password> on page 445

encapsulation 802.1q on page 447

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

434

Page 434
Image 434
HP 7000 dl Router manual Access-policy policyname on