HP 7000 dl Router manual Copyright 2005 Hewlett-Packard Development Company, L.P 755

SROS Command Line Interface Reference Guide PPP Interface Configuration Command Set

ip ospf

Use the ip ospf command to customize OSPF settings (if needed).

Syntax Description

authentication-key		Assign a simple-text authentication password to be used by other routers using
<password>		the OSPF simple password authentication.
cost <value>		Specify the OSPF cost of sending a packet on the interface. This value
		overrides any computed cost value. Range: 1-65535.
dead-interval <seconds>		Set the maximum interval allowed between hello packets. If the maximum is
		exceeded, neighboring devices will determine that the device is down. Range:
		0-32767.
hello-interval <seconds>		Specify the interval between hello packets sent on the interface. Range:
		0-32767.
message-digest-key		Configure OSPF Message Digest 5 (MD5) authentication (16-byte max) keys.
<keyid> md5 <key>
priority <value>		Set the OSPF priority. The value set in this field helps determine the designated
		router for this network. Range: 0-255.
retransmit-interval		Specify the time between link-state advertisements (LSAs). Range: 0-32767.
<seconds>
transmit-delay <seconds>		Set the estimated time required to send an LSA on the interface. Range:
		0-32767.
Default Values
retransmit-interval		5 seconds
<seconds>
transmit-delay <seconds>		1 second
hello-interval <seconds>		10 seconds: Ethernet, point-to-point, Frame Relay, and ppp
dead-interval <seconds>		40 seconds
Command Modes
(config-interface)#	Valid interfaces include: Ethernet (eth 0/1), virtual Frame Relay (fr 1), and virtual
	PPP (ppp 1).

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 755