HP 7000 dl Router manual Serial Interface Configuration Command SET

SROS Command Line Interface Reference Guide Serial Interface Configuration Command Set

SERIAL INTERFACE CONFIGURATION COMMAND SET

To activate the Serial Interface Configuration command set, enter the interface serial command at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface serial 1/1

Router(config-ser 1/1)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933 shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

et-clock-source <source> on page 495 ignore dcd on page 496

invert etclock on page 497 invert rxclock on page 498 invert txclock on page 499 serial-mode <mode> on page 500 shutdown on page 501

snmp trap on page 502

snmp trap link-statuson page 503

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 494