HP 7000 dl Router manual Snmp trap link-status

SROS Command Line Interface Reference Guide PPP Interface Configuration Command Set

snmp trap link-status

Use the snmp trap link-statuscommand to control the SNMP variable that enables (or disables) the interface to send SNMP traps when there is an interface status change (ifLinkUpDownTrapEnable of RFC 2863). Use the no form of this command to disable this trap.

Syntax Description

No subcommands.

Default Values

By default, the ifLinkUpDownTrapEnable OID is enabled for all interfaces except virtual Frame Relay interfaces.

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet (eth 0/1), VLAN, T1 (t1 1/1), E1 (e1 1/1), DSX-1
	(t1 1/2), G.703, serial (ser 1/1), DDS (dds 1/1), virtual Frame Relay (fr 1), virtual
	PPP (ppp 1), SHDSL (shdsl 1/1), and loopback interfaces.

Functional Notes

The snmp trap link-statuscommand is used to control the RFC 2863 ifLinkUpDownTrapEnable OID (OID number 1.3.6.1.2.1.31.1.1.1.14.0).

Usage Examples

The following example disables the link-status trap on the virtual PPP interface:

(config)#interface ppp 1

(config-ppp 1)#no snmp trap link-status

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 777