HP 7000 dl Router manual Interface Configuration Command SET, Interface Configuration Command set

SROS Command Line Interface Reference Guide G.703 Interface Configuration Command set

G.703 INTERFACE CONFIGURATION COMMAND SET

To activate the G.703 Interface Configuration , enter the interface e1 command (and specify the G.703 port) at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface e1 1/2

Router(config-e1 1/2)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933 shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

coding [ami hdb3] on page 546 framing [crc4] on page 547

loopback network [line payload] on page 548 snmp trap link-statuson page 549

test-pattern [511 l clear l insert l ones qrss l show 511 l show qrss l zeros] on page 550 ts16 on page 551

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 545