HP 7000 dl Router Clock source internal line through through t1 interface id, Internal, Through

SROS Command Line Interface Reference Guide T1 Interface Configuration Command Set

clock source [internal line through through t1 <interface id>]

Use the clock source command to configure the source timing used for the interface. The clock specified using the clock source command is also the system master clock. Use the no form of this command to return to the default value.

Syntax Description

internal	Configures the unit to provide clocking using the internal oscillator.
line	Configures the unit to recover clocking from the primary circuit.
through	Configures the unit to recover clocking from the circuit connected to the DSX-1
	interface.
through t1	Configures the unit to recover clocking from the circuit connected to the specified
<interface id>	T1 interface.

Default Values

By default, the clock source is set to line.

Command Modes

(config-t1 1/1)#	T1 or DSX-1 Interface Configuration Mode required.
(config-t1 1/2)#

Functional Notes

When operating on a circuit that is providing timing, setting the clock source to line can avoid errors such as Clock Slip Seconds (CSS).

Usage Examples

The following example configures the unit to recover clocking from the circuit:

(config)#interface t1 1/1

(config-t1 1/1)#clock source line

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 505