HP 7000 dl Router manual Frame Relay Interface Config Command SET

SROS Command Line Interface Reference Guide Frame Relay Interface Config Command Set

FRAME RELAY INTERFACE CONFIG COMMAND SET

To activate the Frame Relay Interface Configuration , enter the interface frame-relaycommand at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface frame-relay 1

Router(config-fr 1)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930 shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

bandwidth <value> on page 568 encapsulation frame-relay ietf on page 569 fair-queue <threshold> on page 570 frame-relay commands begin on page 571 hold-queue <queue size> out on page 583 qos-policy out <mapname> on page 584 snmp trap on page 585

snmp trap link-statuson page 586

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 567