HP 7000 dl Router manual Ignore dcd, Config#interface serial 1/1 config-ser 1/1#ignore dcd

SROS Command Line Interface Reference Guide Serial Interface Configuration Command Set

ignore dcd

Use the ignore dcd command to specify the behavior of the serial interface when the Data Carrier Detect (DCD) signal is lost. Use the no form of this command to return to the default value.

Syntax Description

No subcommands.

Default Values

By default, the serial interface does not ignore a change in status of the DCD signal.

Command Modes

(config-ser 1/1)# Serial Interface Configuration Mode

Functional Notes

When configured to follow DCD (default condition), the serial interface will not attempt to establish a connection when DCD is not present. When configured to ignore DCD, the serial interface will continue to attempt to establish a connection even when DCD is not present.

Usage Examples

The following example configures the serial interface to ignore a loss of the DCD signal:

(config)#interface serial 1/1 (config-ser 1/1)#ignore dcd

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 496