HP 7000 dl Router manual Frame-relay fragment threshold

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

frame-relay fragment <threshold>

Use the frame-relay fragment command to set the FRF.12 fragmentation threshold. Use the no form of this command to erase the configured threshold.

Syntax Description

<threshold>	Valid fragmentation thresholds are greater than or equal to 64 and less than or
	equal to 1600.

Default Values

No default value is necessary for this command.

Command Modes

(config-fr 1.1)# Virtual Frame Relay Sub-Interface Configuration Mode required

Functional Notes

For frame-relay fragmentation to take effect, rate-limiting must be enabled by setting the committed burst rate and excessive burst rate. See frame-relay bc <committed burst value> on page 613 and frame-relay be <excessive burst value> on page 614 for more information.

Usage Examples

The following example enables FRF.12 fragmentation on a sublink:

(config)#interface frame-relay 1.1 (config-fr1.1)#frame-relay bc 64000 (config-fr1.1)#frame-relay be 1

(config-fr1.1)#frame-relay fragmentation 100

disables FRF.12 fragmentation on a sublink: (config)#interface frame-relay 1.1 (config-fr 1.1)#no frame-relay fragment

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 615