HP 7000 dl Router manual Bridge-group group#, Config#interface ppp 1 config-ppp1#bridge-group

SROS Command Line Interface Reference Guide PPP Interface Configuration Command Set

bridge-group <group#>

Use the bridge-groupcommand to assign an interface to the specified bridge group. This command is supported on all Ethernet interfaces, PPP virtual interfaces, and Frame Relay virtual sub-interfaces.

Syntax Description

<group#> Bridge group number (1 to 255) specified using the bridge-groupcommand

Default Values

By default, there are no configured bridge groups.

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), and
	virtual Frame Relay sub-interfaces (fr 1.20).

Functional Notes

A bridged network can provide excellent traffic management to reduce collisions and limit the amount of bandwidth wasted with unnecessary transmissions when routing is not necessary. Any two interfaces can be bridged (Ethernet to T1 bridge, Ethernet to Frame Relay sub-interface, etc.).

Usage Examples

The following example assigns the PPP interface to bridge-group 1:

(config)#interface ppp 1 (config-ppp1)#bridge-group 1

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 725