HP 7000 dl Router manual Loopback Interface Configuration Command SET

SROS Command Line Interface Reference Guide Loopback Interface Configuration Command Set

LOOPBACK INTERFACE CONFIGURATION COMMAND SET

To activate the Loopback Interface Configuration , enter the interface loopback command at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface loopback 1

Router(config-loop 1)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933 shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 848 bandwidth <value> on page 851 crypto map <mapname> on page 852

dynamic-dns [dyndns dyndns-custom dyndns-static] <hostname> <username> <password> on page 855

ip commands begin on page 857 mtu <size> on page 873 snmp trap on page 874

snmp trap link-statuson page 875

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 847