SROS Command Line Interface Reference Guide

Serial Interface Configuration Command Set

 

 

snmp trap

Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP) traps on the interface.

Syntax Description

No subcommands.

Default Values

By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps enabled.

Command Modes

(config-interface)#

Interface Configuration Mode

 

Valid interfaces include: Ethernet (eth 0/1), Ethernet sub-interfaces (eth 0/1.1),

 

VLAN, DDS (dds 1/1), serial (ser 1/1), virtual Frame Relay (fr 1), and SHDSL

 

(shdsl 1/1) interfaces.

Usage Examples

The following example enables SNMP on the serial interface:

(config)#interface serial 1/1 (config-ser 1/1)#snmp trap

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

502

Page 502
Image 502
HP 7000 dl Router manual Snmp trap, Config#interface serial 1/1 config-ser 1/1#snmp trap