HP 7000 dl Router manual Line console telnet line-number ending number, Console

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

line [console telnet] <line-number> <ending number>

Use the line command to enter the line configuration for the specified console or telnet session. See the sections Line (Console) Interface Config Command Set on page 876 and Line (Telnet) Interface Config Command Set on page 887 for information on the subcommands.

Syntax Description

console	Specifies the DB-9 (female) CONSOLE port located on the rear panel of the unit. See
	the sections Line (Console) Interface Config Command Set on page 876 for
	information on the subcommands found in this.
telnet	Specifies a Telnet session(s) to configure for remote access. See the section Line
	(Telnet) Interface Config Command Set on page 887 for information on the
	subcommands found in this.
<line-number>	Specifies the starting Telnet or console session to configure for remote access
	(valid range for console: 0; valid range for Telnet: 0 to 4).
	If configuring a single Telnet session, enter the Telnet session number and leave
	the <ending number> field blank.
<ending number>	Optional. Specifies the last Telnet session to configure for remote access (valid
	range: 0 to 4).
	To configure all available Telnet sessions, enter line telnet 0 4.

Default Values

By default, the Secure Router OS line console parameters are configured as follows:

Data Rate: 9600

Data bits: 8

Stop bits:1

Parity Bits:0

No flow control

By default, there are no configured Telnet sessions.

Command Modes

(config)# Global Configuration Mode required

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 308