HP 7000 dl Router manual Keepalive seconds

SROS Command Line Interface Reference Guide PPP Interface Configuration Command Set

keepalive <seconds>

Use the keepalive command to enable the transmission of keepalive packets on the interface and specify the time interval in seconds between transmitted packets.

Syntax Description

<seconds>	Defines the time interval (in seconds) between transmitted keepalive packets
	(valid range: 0 to 32767 seconds)

Default Values

<seconds>10 seconds

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet (eth 0/1) and virtual PPP interfaces (ppp 1)

Functional Notes

If three keepalive packets are sent to an interface with no response, the interface is considered down. To detect interface failures quickly, specify a smaller keepalive time.

Usage Examples

The following example specifies a keepalive time of 5 seconds on the virtual PPP interface:

(config)#interface ppp 1

(config-ppp 1)#keepalive 5

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 763