SROS Command Line Interface Reference Guide

Global Configuration Mode Command Set

 

 

spanning-tree priority <value>

Use the spanning-tree priority command to set the priority for spanning-tree interfaces. The lower the priority value, the higher the likelihood the configured spanning-tree interface will be the root for the bridge group. To return to the default bridge priority value, use the no version of this command.

Syntax Description

<value>

Priority value for the bridge interface. Configuring this value to a low number

 

increases the interface’s chance of being the root. Therefore, the maximum

 

priority level would be 0. Range: 0-65535.

Default Values

<value>32768

Command Modes

(config)#

Global Configuration Mode required

Usage Examples

The following example sets spanning-tree priority to the maximum level:

(config)#spanning-tree priority 0

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

353

Page 353
Image 353
HP 7000 dl Router manual Spanning-tree priority value, Config#spanning-tree priority