Show qos map

SROS Command Line Interface Reference Guide	Enable Mode Command Set

The show qos map command outputs information about the QoS map. This information differs based on how a particular map entry is defined.

Variations of this command include the following:

show qos map

show qos map interface <interface ID> show qos map <map name>

show qos map <map name> <sequence number>

Syntax Description

<map name>	Enter the name of a defined QoS map.
<sequence number> Enter one of the map’s defined sequence numbers.
<interface>	Specify an interface to display QoS map information for just that interface (e.g.,
	frame-relay, ppp, or atm). Enter the show qos map interface ? command for a
	complete list of interfaces.

Default Values

No defaults necessary for this command.

Command Modes

#	Enable Mode

#show qos map qos map priority map entry 10

match IP packets with a precedence value of 6 priority bandwidth: 400 (kilobits/sec) burst: default packets matched by map: 125520

map entry 20 match ACL icmp

packets matched by map: 99 map entry 30

match RTP packets on even destination ports between 16000 and 17000 packets matched by map: 0

map entry 50 match ACL tcp

5991-2114

179