HP 7000 dl Router manual Network address subnet mask

Router (RIP) Configuration Command Set

network <address> <subnet mask>

Use the network command to enable RIP on the specified network. The Secure Router OS will only allow processing (sending and receiving) RIP messages on interfaces with IP addresses that are contained in the networks listed using this command. All RIP messages received on interfaces not listed using this command will be discarded. To allow for receiving and participating in RIP but not for transmitting, use the passive-interfacecommand (see passive-interface <interface> on page 898). Use the no form of this command to remove a network from the list.

Syntax Description

<address>	IP address of the network on which RIP will be enabled
<subnet mask>	Subnet mask that corresponds to the entered IP address

Default Values

By default, RIP is not enabled.

Command Modes

(config-rip)# Router (RIP) Configuration Mode required

Usage Examples

The following example enables RIP on the 102.22.72.252/30, 192.45.2.0/24, and 10.200.0.0/16 networks:

(config)#router rip

(config-rip)#network 102.22.72.252 255.255.255.252 (config-rip)#network 192.45.2.0 255.255.255.0 (config-rip)#network 10.200.0.0 255.255.0.0

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 897