HP 7000 dl Router manual Config-eth 0/1#snmp trap

SROS Command Line Interface Reference Guide Loopback Interface Configuration Command Set

snmp trap

Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP) traps on the interface.

Syntax Description

No subcommands.

Default Values

By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps enabled.

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), Ethernet sub-interfaces (eth 0/1.1), VLAN, DDS (dds 1/1), serial (ser 1/1), virtual Frame Relay (fr 1), and SHDSL (shdsl 1/1) interfaces.

Usage Examples

The following example enables SNMP capability on the Ethernet interface:

(config)#interface eth 0/1

(config-eth 0/1)#snmp trap

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 874