HP 7000 dl Router manual Interface

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

mac address-table static <mac address> vlan <vlan id> interface [ethernet atm] <interface id>

Use the mac address-table static command to insert a static MAC address entry into the MAC address table. Use the no form of this command to remove an entry from the table.

Syntax Description

<mac address>	Enter a valid 48-bit MAC address.
<vlan id>	Enter a valid VLAN interface ID (1-4094).
interface	Choose either the ethernet or atm interface.
<interface id>	Enter any valid slot/port interface ID (e.g., eth 0/1).

Default Values

By default, there are no static entries configured.

Command Modes

(config)# Global Configuration Mode required

Usage Examples

The following example adds a static MAC address to Ethernet 0/1 on VLAN 4:

(config)#mac address-table static 00:12:79:00:00:01 vlan 4 interface ethernet 0/1

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 325