HP 7000 dl Router manual Area area id stub no-summary, Config#router ospf

Router (OSPF) Configuration Command Set

area <area id> stub [no-summary]

Use this command to configure an area as a stub area. Use the no form of this command to disable stub-designation for areas defined as stubs using this command.

Syntax Description

<area id>	Identifier for this stub area. Enter as an integer (range: 0-4294967295) or an IP
	address <A.B.C.D>.
no-summary	Optional. Use this optional keyword to designate the area as a total stub area. No
	summary link advertisements will be sent by the ABR into the stub area.

Default Values

By default, OSPF is not enabled.

Command Modes

(config-ospf)# Router (OSPF) Configuration Mode required

Technology Review

It is important to coordinate configuration of all routers and access servers in the stub area. The area stub command must be configured for each of those pieces of equipment. Use the area router configuration command with the area default-costcommand to specify the cost of a default internal router sent into a stub area by an ABR. See area <area id> default-cost <value> on page 904 for related information.

Usage Examples

(config)#router ospf

(config-ospf)#area 2 stub

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 906