SROS Command Line Interface Reference Guide

HDLC Command Set

 

 

ip proxy-arp<ip address> <subnet mask>

Use the ip proxy-arpcommand to enable proxy Address Resolution Protocol (ARP) on the interface. Use the no form of this command to disable this feature.

Syntax Description

<ip address>

Defines the proxy ARP IP address in dotted decimal notation (for example:

 

192.22.73.101).

<subnet mask>

Specifies the subnet mask that corresponds to the listed IP address.

Default Values

By default, proxy-arp is enabled.

Command Modes

(config-interface)#

Interface Configuration Mode

 

Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), virtual

 

HDLC interfaces (hdlc 1), virtual Frame Relay sub-interfaces (fr 1.20), tunnel

 

interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

In general, the principle of proxy ARP allows a router to insert its IP address in the source IP address field of a packet (if the packet is from a host on one of its subnetworks). This allows hosts to reach devices on other subnetworks without implementing routing or specifying a default gateway.

If proxy ARP is enabled, the SROS will respond to all proxy ARP requests with its specified MAC address and forward packets accordingly.

Enabling proxy ARP on an interface may introduce unnecessary ARP traffic on the network.

Usage Examples

The following enables proxy ARP on the HDLC interface:

(config)#interface hdlc 1

(config-hdlc 1)#ip proxy-arp

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

836

Page 836
Image 836
HP 7000 dl Router manual Following enables proxy ARP on the Hdlc interface