HP 7000 dl Router T1 Interface Configuration Command SET, T1 Interface Configuration Command Set

SROS Command Line Interface Reference Guide T1 Interface Configuration Command Set

T1 INTERFACE CONFIGURATION COMMAND SET

To activate the T1 Interface Configuration , enter the interface t1 command at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface t1 1/1

Router(config-t1 1/1)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

clock source [internal line through through t1 <interface id>] on page 505 coding [ami b8zs] on page 506

fdl [ansi att none] on page 507 framing [d4 esf] on page 508 lbo long <value> on page 509 lbo short <value> on page 510 loopback commands begin on page 511 remote-alarm [rai] on page 514 remote-loopbackon page 515

show test-patternon page 516 snmp trap link-statuson page 517

tdm-group <group number> timeslots <1-24> speed [56 64] on page 518 test-pattern [ones zeros clear insert p215 p220 p511 qrss] on page 519

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 504