HP 7000 dl Router Router RIP Configuration Command SET, Router RIP Configuration Command Set

Router (RIP) Configuration Command Set

ROUTER (RIP) CONFIGURATION COMMAND SET

To activate the Router (RIP) Configuration , enter the router rip command at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#router rip

Router(config-rip)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 do on page 928

end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

auto-summaryon page 895 default-metric <value> on page 896

network <address> <subnet mask> on page 897 passive-interface <interface> on page 898 redistribute connected [metric <value>] on page 899 redistribute ospf [metric <value>] on page 900 redistribute static [metric <value>] on page 901 version <version> on page 902

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 894