HP 7000 dl Router manual Framing crc4, Config#interface e1 1/2

SROS Command Line Interface Reference Guide G.703 Interface Configuration Command set

framing [crc4]

Use the framing command to configure the framing format for the G.703 interface. This parameter should match the framing format set on the external device. Use the no form of this command to return to the default value.

Syntax Description

crc4	Enables CRC4 bits to be transmitted in the outgoing data stream. Also, the
	received signal is checked for CRC4 errors.

Default Values

By default, CRC4 is enabled.

Command Modes

(config-e1 1/1)#	E1 or G.703 Interface Configuration Mode required.
(config-e1 1/2)#

Functional Notes

The framing value must match the configuration of the E1 circuit. A mis-match will result in a loss of frame alarm.

Usage Examples

The following example configures the G.703 interface for CRC4 framing:

(config)#interface e1 1/2

(config-e1 1/2)#framing crc4

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 547