HP 7000 dl Router manual Spanning-tree edgeport disable

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

spanning-tree edgeport [disable]

Use the spanning-tree edgeport command to set this interface to be an edgeport. This configures the interface to go to a forwarding state when the link goes up. To return to the default value, use the no form of this command.

Syntax Description

disable	Optional. Configure the interface to not be the edgeport by default. This command is
	designed to override the global setting of the bridge-group <group#> edgeport
	default on page 247.

Default Values

By default, this command is set to disable.

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), and
	virtual Frame Relay sub-interfaces (fr 1.20)

Usage Examples

The following example configures the interface to be an edgeport:

(config)#interface frame-relay 1.16 (config-fr1.16)#spanning-tree edgeport

An individual interface can be configured to not be considered an edgeport. For example: (config)#interface frame-relay 1.16

(config-fr1.16)#spanning-tree edgeport disable or

(config)#interface frame-relay 1.16 (config-fr 1.16)#no spanning-tree edgeport

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 640