HP 7000 dl Router manual Line Telnet Interface Config Command SET

Line (Telnet) Interface Config Command Set

LINE (TELNET) INTERFACE CONFIG COMMAND SET

To activate the Line (Telnet) Interface Configuration , enter the line telnet command specifying a Telnet session(s) at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#line telnet 0 4

Router(config-telnet0-4)#

You can select a single line by entering the line telnet command followed by the line number (0-4). For example:

Router> enable

Router#configure terminal

Router(config)#line telnet 2

Router(config-telnet2)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

do on page 928 end on page 929 exit on page 930

All other commands for this command set are described in this section in alphabetical order.

access-class <listname> in on page 888 line-timeout <minutes> on page 889

login on page 890

login authentication <aaa login list> on page 891 login local-userliston page 892

password [md5] <password> on page 893

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 887