HP 7000 dl Router manual Bonding txadd-timer seconds

SROS Command Line Interface Reference Guide BRI Interface Configuration Command set

bonding txadd-timer <seconds>

Use the bonding txadd-timercommand to specify the value (in seconds) for the aggregate call connect timeout. Use the no form of this command to return to the default value.

Syntax Description

<seconds>	Specifies the number of seconds the endpoint will wait for additional channels (to
	add to the bonded aggregate) before considering the BONDING negotiation a
	failure

Default Values

<seconds> 50 seconds

Command Modes

(config-bri 1/2)# BRI Interface Configuration Mode required

Functional Notes

Specifies the length of time both endpoints wait for additional calls to be connected at the end of negotiation before deciding that the BONDING call has failed. The factory default setting is sufficient for most calls to connect, although when dialing overseas it may be necessary to lengthen this timer to allow for slower call routing.

Usage Examples

The following example defines a txadd-timer value of 95 seconds:

(config)#interface bri 1/2

(config-bri 1/2)#bonding txadd-timer 95

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 557