HP 7000 dl Router manual DSX-1 Interface Configuration Command SET

SROS Command Line Interface Reference Guide DSX-1 Interface Configuration Command Set

DSX-1 INTERFACE CONFIGURATION COMMAND SET

To activate the DSX-1 Interface Configuration , enter the interface t1 command (and specify the DSX-1 port) at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface t1 1/2

Router(config-t1 1/2)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

alias <“text”> on page 923

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933 shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

coding [ami b8zs] on page 521 framing [d4 esf] on page 522 line-length <value> on page 523

loopback network [line payload] on page 524 loopback remote line inband on page 525 remote-loopbackon page 526

signaling-mode[message-oriented none robbed-bit]on page 527 snmp trap link-statuson page 528

test-pattern [ones zeros] on page 529

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 520