HP 7000 dl Router manual Default-metric value

Router (RIP) Configuration Command Set

default-metric <value>

Use the default-metriccommand to set the default metric value for the RIP routing protocol. Use the no form of this command to return to the default settings.

Syntax Description

<value> Set the default metric value (range: 1-4294967295 Mbps).

Default Values

By default, this value is set at 0.

Command Modes

(config-ospf)#	Router (OSPF or RIP) Configuration Mode required
(config-rip)#

Functional Notes

The metric value defined using the redistribute command overrides the default-metriccommand’s metric setting. See redistribute ospf [metric <value>] on page 900 for related information.

Usage Examples

The following example shows a router using both RIP and OSPF routing protocols. The example advertises OSPF-derived routes using the RIP protocol and assigns the OSPF-derived routes a RIP metric of 10.

(config)#router rip

(config-rip)#default-metric 10 (config-rip)#redistribute ospf

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 896