HP 7000 dl Router manual Radius Group Command SET, Radius Group Command Set

SROS Command Line Interface Reference Guide Radius Group Command Set

RADIUS GROUP COMMAND SET

To activate the Radius Group , enter the aaa group server command at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#aaa group server radius myServer

Router(config-sg-radius)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

server [acct-port <port number> auth-port <port number>] on page 417

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 416