HP 7000 dl Router manual Loopback remote line fdl inband, Fdl, Inband

SROS Command Line Interface Reference Guide T1 Interface Configuration Command Set

loopback remote line [fdl inband]

Use the loopback remote line command to send a loopback code to the remote unit to initiate a line loopback. Use the no form of this command to send a loopdown code to the remote unit to deactivate the loopback.

Syntax Description

fdl	Uses the facility data link (FDL) to initiate a full 1.544 Mbps loopback of the signal
	received by the remote unit from the network.
inband	Uses the inband channel to initiate a full 1.544 Mbps physical loopback (metallic
	loopback) of the signal received from the network.

Default Values

No defaults necessary for this command.

Command Modes

(config-t1 1/1)# T1 Interface Configuration Mode required (does not apply to DSX-1 interfaces)

Functional Notes

The following diagram depicts the difference between a line and payload loopback.

DS1

NI CSU

T1 Network Interface

Payload Loopback

Line Loopback

Usage Examples

The following example initiates a remote line loopback using the FDL:

(config)#interface t1 1/1

(config-t1 1/1)#loopback remote line fdl

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 512