HP 7000 dl Router manual Frame-relay bc committed burst value

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set

frame-relay bc <committed burst value>

Use the frame-relay bc command to set the bc (committed burst) value for a Frame Relay sublink. The value is in bits. Use the no form of this command to return to default.

Syntax Description

<committed burst value> Enter the committed burst value (in bits) for the sublink.

Default Values

The default is 0 (no limit).

Command Modes

(config-fr 1.1)# Virtual Frame Relay Sub-Interface Configuration Mode required

Functional Notes

The time interval is always one second, so this can also be considered bits per second. Shaping is performed on a sliding one-second window to make maximum use of configured bandwidth. Note that when both bc and be are non-zero, shaping is performed on the virtual circuit. The circuit is limited to the sum of bc and be , and it is recommended that the sum always be greater than 8000.

Usage Examples

The following example configures sublink fr 1.1 with a committed burst value of 128000 bits:

(config)#interface fr 1.1

(config-fr1.1)#frame-relay bc 128000

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 613