HP 7000 dl Router manual Parity option, Config#line console 0 config-con 0#parity mark

SROS Command Line Interface Reference Guide Line (Console) Interface Config Command Set

parity <option>

Use the parity command to specify the type of parity used as error correction. This value must match the configuration of your VT100 terminal or terminal emulator software. Use the no form of this command to return to the default value.

Syntax Description

<option>	Specifies the type of data parity on the interface
even	The parity bit is set to 0 if the number of 1 bits in the data sequence is odd, or set
	to 1 if the number of 1 bits is even.
mark	The parity bit is always set to 1.
none	No parity bit used.
odd	The parity bit is set to 1 if the number of 1 bits in the data sequence is even, or set
	to 1 if the number is odd.
space	The parity bit is always set to 0.

Default Values

<option>none

Command Modes

(config-con 0)# Console Interface Configuration Mode required

Functional Notes

Parity is the process used to detect whether characters have been altered during the data transmission process. Parity bits are appended to data frames to ensure that parity (whether it be odd or even) is maintained.

Usage Examples

The following example specifies mark parity for the console terminal session:

(config)#line console 0 (config-con 0)#parity mark

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 883