HP 7000 dl Router manual Basic Mode Command SET, Basic Mode Command Set

SROS Command Line Interface Reference Guide Basic Mode Command Set

BASIC MODE COMMAND SET

To activate the Basic Mode, simply log in to the unit. After connecting the unit to a VT100 terminal (or terminal emulator) and activating a terminal session, the following prompt displays:

Router>

The following command is common to multiple command sets and is covered in a centralized section of this guide. For more information, refer to the section listed below:

exit on page 930

All other commands for this command set are described in this section in alphabetical order.

enable on page 11 logout on page 12

ping <address> on page 13 show clock on page 15 show snmp on page 16 show version on page 17 telnet <address> on page 18 traceroute <address> on page 19

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 10