#show interfaces modem 1/2 modem 1/2 is UP

SROS Command Line Interface Reference Guide	Enable Mode Command Set

T1 coding is B8ZS framing is ESF

Clock source is line FDL type is ANSI

Line build-out is 0dB

No remote loopbacks No network loopbacks

DS0 Status: 123456789012345678901234

Line Status: -- No Alarms --

Current Performance Statistics:

0 Errored Seconds 0 Bursty Errored Seconds

0 Severely Errored Seconds 0 Severely Errored Frame Seconds

0 Unavailable Seconds 0 Path Code Violations

0 Line Code Violations 0 Controlled Slip Seconds

0 Line Errored Seconds 0 Degraded Minutes

Line status: on-hook

Caller ID will be used to route incoming calls 0 packets input 0 bytes 0 no buffer

0 runts 0 giants 0 throttles

0 input errors 0 CRC 0 frame

0 abort 0 ignored 0 overruns

0 packets output 0 bytes 0 underruns

0 input clock glitches 0 output clock glitches

0 carrier lost 0 cts lost

#show interfaces eth 0/1 Ip address is 10.200.1.50 Netmask is 255.255.0.0

MTU is 1500 Fastcaching is Enabled

RIP Authentication is Disabled RIP Tx uses global version value RIP Rx uses global version value

#show interfaces dds 1/1

dds 1/1 is UP line protocol is UP Encapsulation FRAME-RELAY (fr 1)

Loop rate is set to 56000 actual rate is 56000 Clock source is line

Data scrambling is disabled No Loopbacks

75 packets input 6108 bytes 0 no buffer

5991-2114

133