HP 7000 dl Router manual Ip rip send version version

SROS Command Line Interface Reference Guide Ethernet Interface Configuration Command Set

ip rip send version <version>

Use the ip rip send version command to configure the RIP version the unit sends in all RIP packets transmitted on the interface.

Syntax Description

<version>	Specifies the RIP version
1	Only transmits RIP version 1 packets on the interface
2	Only transmits RIP version 2 packets on the interface

Default Values

By default, all interfaces transmit RIP version 1 (the default value for the version command).

Command Modes

(config-interface)#	Interface Configuration Mode required (applies to all physical interfaces as well as
	virtual interfaces)

Functional Notes

Use the ip rip send version to specify a RIP version that overrides the version (in the Router RIP ) configuration.

The Secure Router OS only transmits one version (either 1 or 2) on a given interface.

Usage Examples

The following example configures the Ethernet interface to transmit only RIP version 2 packets:

(config)#interface eth 0/1 (config-eth 0/1)#ip rip send version 2

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 468