HP 7000 dl Router BGP Neighbor Configuration Command SET, BGP Neighbor Configuration Command Set

SROS Command Line Interface Reference Guide BGP Neighbor Configuration Command Set

BGP NEIGHBOR CONFIGURATION COMMAND SET

To activate the BGP Neighbor Configuration, enter the bgp-neighborcommand at the Global Configuration Mode prompt. For example:

Switch>enable

Switch#configure terminal

Switch(config)#bgp-neighbor

Switch(config-bgp-neighbor)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

exit on page 930

All other commands for this command set are described in this section in alphabetical order.

advertisement-interval <seconds> on page 712 ebgp-multihop <hop count> on page 713 hold-timer <hold time> on page 714

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 711