HP 7000 dl Router manual ATM SUB-INTERFACE Config Command SET

SROS Command Line Interface Reference Guide ATM Sub-Interface Config Command Set

ATM SUB-INTERFACE CONFIG COMMAND SET

To activate the ATM Interface Configuration , enter the interface atm command (and specify a sub-interface) at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface atm 1.1

Router(config-atm 1.1)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 exit on page 930

ping <address> on page 931 show running-configon page 933 shutdown on page 935

All other commands for this command set are described in this section in alphabetical order. access-policy <policyname> on page 648

atm routed-bridged [ip] on page 649 backup commands begin on page 652 bandwidth <value> on page 660 bridge-group <group#> on page 661 crypto map <mapname> on page 662

dynamic-dns [dyndns dyndns-custom dyndns-static] <hostname> <username> <password> on page 664 encapsulation [aal5mux aal5snap] on page 666

fair-queue <threshold> on page 667 hold-queue <queue size> out on page 668 ip commands begin on page 669

mtu <size> on page 690

oam commands begin on page 691 pvc <VPI/VCI> on page 693 qos-policy out <mapname> on page 694 spanning-tree commands begin on page 696

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 647