HP 7000 dl Router manual Config-eth 0/1#lldp send-and-receive

SROS Command Line Interface Reference Guide Ethernet Interface Configuration Command Set

lldp send [management-address l port-description l system-capabilities l system-description l system-name l and-receive]

Use the lldp send command to configure this interface to transmit LLDP packets or to control the types of information contained in the LLDP packets transmitted by this interface.

Syntax Description

management-addressEnables transmission of management adress information on this interface.

port-description	Enables transmission of port description information on this interface.
system-capabilities	Enables transmission of this device’s system capabilities on this interface.
system-description	Enables transmission of this device’s system description on this interface.
system-name	Enables transmission of this device’s system name on this interface.
and-receive	Configures this interface to both transmit and receive LLDP packets.

Default Values

Be default, all interfaces are configured to transmit and receive LLDP packets of all types.

Command Modes

(config-interface)# Ethernet Command Mode

Functional Notes

Individual LLDP information can be enabled or disabled using the various forms of the lldp send command. For example, use the lldp send-and-receivecommand to enable transmit and receive of all LLDP information. Then use the no lldp send port-descriptioncommand to prevent LLDP from transmitting port description information.

Usage Examples

The following example configures Ethernet interface 0/1 to transmit LLDP packets containing all enabled information types:

(config-eth 0/1)#lldp send

The following example configures Ethernet interface 0/1 to receive LLDP packets containing all information types:

(config-eth 0/1)#lldp send-and-receive

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 472