HP 7000 dl Router manual Config#interface hdlc Config-hdlc 1#no snmp trap link-status

SROS Command Line Interface Reference Guide HDLC Command Set

snmp trap link-status

Use the snmp trap link-statuscommand to control the SNMP variable ifLinkUpDownTrapEnable (RFC2863), which enables (or disables) the interface to send SNMP traps when there is an interface status change. Use the no form of this command to disable this trap.

Syntax Description

No subcommands.

Default Values

By default, the ifLinkUpDownTrapEnable OID is enabled for all interfaces except virtual Frame Relay interfaces.

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), virtual
	HDLC interfaces (hdlc 1), virtual Frame Relay sub-interfaces (fr 1.20), tunnel
	interfaces (tunnel 1), and VLAN interface (vlan 1).

Functional Notes

The snmp trap link-statuscommand is used to control the RFC2863 ifLinkUpDownTrapEnable OID (OID number 1.3.6.1.2.1.31.1.1.1.14.0).

Usage Examples

The following example disables the link-status trap on the HDLC interface:

(config)#interface hdlc 1

(config-hdlc 1)#no snmp trap link-status

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 846