HP 7000 dl Router manual Snmp trap, Config#interface atm

SROS Command Line Interface Reference Guide ATM Interface Config Command Set

snmp trap

Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP) traps on the interface.

Syntax Description

No subcommands.

Default Values

By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps enabled.

Command Modes

(config-interface)#	Interface Configuration Mode
	Valid interfaces include: Ethernet, Ethernet sub-interfaces, ATM, VLAN, DDS,
	serial , virtual Frame Relay, and SHDSL interfaces.

Usage Examples

The following example enables SNMP on the ATM interface:

(config)#interface atm 1

(config-atm 1)#snmp trap

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 645