HP 7000 dl Router manual PPP Interface Configuration Command SET

SROS Command Line Interface Reference Guide PPP Interface Configuration Command Set

PPPINTERFACE CONFIGURATION COMMAND SET

To activate the PPP Interface Configuration , enter the interface ppp command at the Global Configuration Mode prompt. For example:

Router>enable

Router#configure terminal

Router(config)#interface ppp 1

Router(config-ppp 1)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933 shutdown on page 935

All other commands for this command set are described in this section in alphabetical order.

access-policy <policyname> on page 717 alias link<“text”> on page 720 bandwidth <value> on page 721 bridge-group commands begin on page 725 crypto map <mapname> on page 731 crypto map <mapname> on page 731 backup commands begin on page 733

dynamic-dns [dyndns dyndns-custom dyndns-static] <hostname> <username> <password> on page 742

fair-queue <threshold> on page 744 hold-queue <queue size> out on page 745 ip commands begin on page 746 keepalive <seconds> on page 763

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 715