HP 7000 dl Router manual Hardware-addresshardware-address type, Ieee802

SROS Command Line Interface Reference Guide DHCP Pool Command Set

hardware-address<hardware-address> <type>

Use the hardware-addresscommand to specify the name of a Dynamic Host Configuration Protocol (DHCP) client. Use the no form of this command to remove the configured client name.

Syntax Description

<hardware-address>	Specifies the hardware address (in hexadecimal notation with colon delimiters) of
	the preferred router on the client’s subnet (example d2:17:04:91:11:50).
<type>	Optional. Specifies the hardware protocol of the DHCP client.
	The hardware type field can be entered as follows:
ethernet	Specifies standard Ethernet networks.
ieee802	Specifies IEEE 802 standard networks.
<1-21>	Enter one of the hardware types listed in RFC 1700.

The valid hardware types are as follows:

110 Mb Ethernet

2Experimental 3 Mb Ethernet

3Amateur Radio AX.25

4Proteon ProNET Token Ring

5Chaos

6IEEE 802 Networks

7ARCNET

8Hyperchannel

9Lanstar

10Autonet Short Address

11LocalTalk

12LocalNet (IBM PCNet or SYTEK LocalNet)

13Ultra link

14SMDS

15Frame Relay

16Asynchronous Transmission Mode (ATM)

17HDLC

18Fibre Channel

19Asynchronous Transmission Mode (ATM)

20Serial Line

21Asynchronous Transmission Mode (ATM)

Default Values

<type>1 - 10 Mb Ethernet

Command Modes

(config-dhcp)# DHCP Pool

5991-2114 © Copyright 2005 Hewlett-Packard Development Company, L.P. 362