SROS Command Line Interface Reference Guide

Global Configuration Mode Command Set

 

 

GLOBAL CONFIGURATION MODE COMMAND SET

To activate the Global Configuration Mode, enter the configuration command at the Enable security mode prompt. For example:

Router> enable

Router#configure terminal

Router(config)#

The following commands are common to multiple command sets and are covered in a centralized section of this guide. For more information, refer to the sections listed below:

exit on page 930

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924 description on page 927

do on page 928 end on page 929 exit on page 930

ping <address> on page 931 show running-configon page 933

All other commands for this command set are described in this section in alphabetical order.

aaacommands begin on page 202

banner [exec login motd] <character> <message> <character> on page 210

bridge commands begin on page 211boot config [cflash flash] <filename> [cflash flash] <backup file> on page 212

boot system [cflash flash] <filename> [cflash flash] [no-backup <backup filename>] on page 213 enable password [md5] <password> on page 234

event-history on on page 235

event-history priority [error fatal info notice warning] on page 236 ftp authentication <listname> on page 238

hostname <name> on page 239 interface commands begin on page 240

ip access-list extended <listname> on page 250

line [console telnet] <line-number> <ending number> on page 308

lldp [minimum-transmit-interval l reinitialization-delay l transmit-interval l ttl-multiplier] <numeric value> on page 310

5991-2114

© Copyright 2005 Hewlett-Packard Development Company, L.P.

200

Page 200
Image 200
HP 7000 dl Router manual Global Configuration Mode Command SET, Router#configure terminal